Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION
CLOCK SETTING
When the microwave oven is plugged into an outlet, " : 0" will display.
(1) Press Timer/Clock once, "12H" will appear in the display.
(2) Press the number pads and enter the current clock time. For example, if the time is now 8:30,
press "8, 3, 0" in order. The numbers will flash in the display.
(3) Press Timer/Clock to finish clock setting, ":" will flash and the numbers will appear as a clock
time in the display.
Note: (1) If you make a number entry mistake while in the process of setting clock, press
to start over.
(2) This is a 12 hour clock. If the numbers entered are not within the range between 1:00
to 12:59, the setting will not be accepted until valid numbers are entered.
TIMER
(1) Press Timer/Clock twice, " : 0" and TIMER indicator "v" will appear in the display window.
(2) Press the number pads to enter the time amount. The maximum amount of time that can be
enter is 99 minutes 99 seconds.
(3) Press
to confirm setting.
(4) When the time amount elapses, the control panel will beep 3 times.
Note: The Timer setting is different from the Clock setting; it is simply a timer.
MICROWAVE COOK
(1) Press Micro, " : 0" and MICRO (Microwave) indicator "v" will appear in the display window.
(2) Press number pads to enter the cooking time; the maximum cooking time is 99 minutes and
99 seconds.
(3) Press Power Level ; PL10 will display. This is the default power level of 100%. Press number
pads 0 through 9 to select a different power level if desired. See the Power Level table
below.
(4) Press
to start cooking. Countdown will begin in display window.
Example: To cook the food with 50% microwave power for 15 minutes.
a. Press the Time Cook, " : 0" and M/W (Microwave) indicator "v" will appear in the
display window.
b. Press "1, 5, 0, 0" in order for 15:00 to appear in the display.
c. Press Power Level, then press "5" to select 50% microwave power.
d. Press
to start cooking. Countdown will begin in display window.
Note: In the process of setting, if the
mode.
pad is pressed, the display will return to standby
EN-10
Tabla de contenido
