Kohler K-1997 Guía De Instalación Y Cuidado página 7

Shroud
Holes
3. Prepare the Shroud Installation
If you are not installing a shroud with your sink, proceed to the next
section.
NOTE: This product is heavy. Get help when lifting and securing
the shroud.
With assistance, carefully position and center the shroud tight
against the underside of the sink. Mark the three shroud hole
locations on the finished wall.
Carefully remove the shroud and sink.
Draw a level line connecting the top shroud hole marks. Measure
3-1/2" (89 mm) on each side of the centerline to mark the top two
angle bracket holes.
For the bottom angle bracket hole, measure and mark the
centerline 1-5/8" (41 mm) above the bottom shroud hole mark.
Use lag bolts (not provided) to secure the three angle brackets to
the wall at the marked locations.
Kohler Co.
Sink Anchor
Holes
3-1/2" (89 mm)
Angle Bracket
Holes
Lag Bolt
7
3-1/2"
(89 mm)
1-5/8"
(41 mm)
1208746-2-A