Specifications - Tripp-Lite SmartPro Manual De Operación

Specifications

Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.
Output Capacity (VA/Watts):
Battery Runtime
(Half Load/Full Load) Minutes:
Battery Recharge Time:
Approvals:
Modem/Fax Protection:
External Battery Type:
Output Capacity (VA/Watts):
Battery Runtime
(Half Load/Full Load) Minutes:
Battery Recharge Time:
Approvals:
Modem/Fax Protection:
External Battery Type:
ALL MODELS:
Input Voltage/Frequency (120V/60 Hz); Output Waveform Line Mode (filtered sinewave); Output Waveform Battery Mode (PWM
sine wave); AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40 dB); AC Protection
Modes (H to N, H to G, N to G).
UL CLASSIFICATION FOR MEDICAL EQUIPMENT:
Class I, Type B, Ordinary Equipment, Continuous Operation.
UL1778 APPROVAL:
All the UPS systems described in this manual are UL1778 listed. All meet strict requirements for UPS protection. They provide battery
backup during blackouts, switching between utility power and battery backup power in 2-4 milliseconds. All are designed to
produce extremely low leakage to ground. In addition, all have hospital-grade plugs and receptacles that reduce the possibility of
accidental equipment disconnection. All are suitable for use in hospitals, outside patient care areas.
UL2601-1 APPROVAL:
Several of the UPS models described in this manual are UL 2601-1 listed (see specifications). They incorporate Faraday-shielded isola-
tion transformers that reduce the cumulative leakage current of all connected equipment to below 300 microamps. These models
are suitable for use in hospitals, including inside patient care areas.
FCC CLASS A RADIO/TV INTERFERENCE NOTICE:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when operated in a com-
mercial environment. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual, may cause interference to radio communications. Operation of this equipment is likely to
cause harmful interference in which case the user will be required to correct the interference at his own expense. The user must
use shielded cables and connectors with this product. Any changes or modifications to this product not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
FCC CLASS B RADIO/TV INTERFERENCE NOTICE (U.S. ONLY):
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference using one or more of the
following measures: reorient or relocate the receiving antenna; increase the separation between the equipment and the receiver;
connect the equipment into an outlet on a circuit different from that which the receiver is connected; consult the dealer or an experienced
radio/television technician for help. The user must use shielded cables and connectors with this product. Any changes or modifications
to this product not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
OMNISMART350HG
330/225
46/18
2-4 hrs.
UL1778, UL2601-1
FCC Class B and Part 68
2 lines
None
SMART700HG
700/450
42/18
2-4 hrs.
UL1778, UL2601-1
FCC Class A
None
None
10
OMNISMART450HG
450/280
38/14
2-4 hrs.
UL1778
FCC Class B
None
None
SMART1200XLHG
1000/750
28+/11+
2-4 hrs.
UL1778, UL2601-1
FCC Class A
None
BP36V27
OMNISMART700HG
700/425
22/9
2-4 hrs.
UL1778
FCC Class B
None
None