Kohler Purist K-T14428 Guia De Instalacion página 6

o
l
r a
r a r
or a r
o
al
o
3. Installation on Rough (Unfinished) Deck
Use 1/2" nominal, 5/8" O.D. copper tubing. Cut two pieces of tubing to a
length of 2–7/8" (7.3cm). Cut one piece of tubing to a length of 2–3/8"
(6cm) for the spout supply.
IMPORTANT! Leave the protective sleeve on the spout supply tube until
the spout is installed to protect the O-ring sealing surface.
Install Spout Supply Tube
Slide a brass washer from the bottom of the spout supply tube over the
threads until the washer reaches the supply tube shoulder. Ensure that the
countersunk holes in the washer are facing upward.
Insert the spout supply tube through the mounting hole from the top of the
deck. Ensure that the flat portion of the washer faces forward. The supply
tube will be suspended by the washer.
Slide a brass washer onto the spout supply tube from the bottom and
thread the mounting nut. Tighten the nut.
Secure the brass washer to the deck using the two supplied wood screws.
Install Valve Bodies
Thread one mounting nut, flange side up, followed by one fiber washer and
one rubber washer onto each valve body.
Insert the 2–7/8" (7.3cm) long copper tubes between the valve bodies and
the 1/2" tee.
Do not solder the connections at this time.
1016271-2-A
l
r
o l r
r
"
Co r
ol
o
l ol
6
1"
Collar
r
ra a
ol r
Col
1 " 1
r
"
r
Co r
Kohler Co.
r
l