Mounting The Light Fixture; Testing And Adjustments; Initial Setup - Heath Zenith DualBrite 4010 Manual Del Usuario

MOUNTING THE LIGHT FIXTURE

1. Make sure wire connectors and wires are inside the
junction box.
2. Slide the fixture assembly onto the mounting screws.
Tighten decorative nuts removed in step 1 of Light
Fixture Installation section securely against fixture base.
Decorative Nut
3. Install one medium base light bulb (100 Watt maximum,
tungsten incandescent).
4. Replace globe assembly onto fixture.
5. Secure with decorative screws.
Fixture Cap
Light Bulb
Globe
Assembly
6. Caulk around fixture base with silicone weather sealant.
Mounting Screw
The TEST mode overrides the photocell (daylight shutoff
feature) and allows the light fixture to be tested day or night
when the ON-TIME switch is in the TEST position. The
light will stay on for 5 seconds after all motion has stopped.
Junction
Box
1. Turn the DualBrite control to OFF.
2. Set the ON-TIME control to TEST.
3. Set sensitivity control (SENS) to MIN position.
4. Turn on the circuit breaker or fuse and the light switch.
5. Allow the sensor to completely warm up (90 seconds)
before beginning the setup process.
6. Perform a walk test. Walk in an arc across the front of
the sensor.
Decorative
6 ft .
Screw
(1 .8 m)
6
Caulking Around Fixture Base

TESTING AND ADJUSTMENTS

Initial Setup

SENS
– +
TEST 1 5 10
MINUTE
Sensor Controls
30 ft . (9 .1 m)
Maximum Range
OFF 3 6 DUSK TO
HOUR DAWN
150°
Maximum Coverage
Angle (Top View)
209176-03