Power On And Off; Pairing With A Bluetooth Device - Trevi X-DJ 13E80 ANC Guia Del Usuario

ENGLISH
Headphones have an internal rechargeable battery, the first time you use headphones, make a charge
for 3-4 hours; a fully charged battery headphones have a battery life of about 10 hours of music
listening.
When the headset indicates a low battery, turn Off the headset and charge it:
- Connect the included Micro USB cable to an external device equipped with USB port (computer,
tablet...) or to a power supply with USB 5V
- Connect the supplied USB cable into the Micro USB connector (6); while charging the red LED
indicator (4) will light;
- Charging is completed, the LED light will be Off'.
Indication of battery being phased out:
- When the battery is low, you will hear the message "LOW BATTERY" a few times then the
headset will automatically turn off.
ANC (ACTIVE NOISE CONTROL): ON/OFF
The ANC circuit actually senses external noise through the built-in microphone and sends unit itself
equal and opposite cancellation signels.
- The ANC effect may not be noticeable in a very quiet environment, or you may hear little noise.
- The ANC effect may vary depending on how you put the unit or buzzing (squeaking) may occur. In this
case, remove the unit and then wear it again.
- The ANC function is mainly effective for low frequency noise. The noise can be reduced, but it can not be
completely eliminated.
- The mobile phone may cause interference and noise to the unit. If this happens, pleace the unit away from
the mobile phone.
- Do not cover the microphone of this unit with your hand, the ANC function may not function properly or
buzzing may occur (squeak).
Turn On: When the ANC function is Off, turn the ANC switch On (7) then the ANC indicator (4)
•
will be On;
Turn Off: When the ANC function is enabled, turn the ANC switch Off (7) then the ANC indicator
•
(4) will be Off.

POWER ON AND OFF

• Turn ON: In power Off status, long press
and the Blue light flash.
• Turn Off: In power On statur, press and hold
Off" and the Red indicator (4) light will blink and then be off.
Auto Turn off: after a period of inactivity with Bluetooth pairing inactive, the headphones automati-
cally turn off. To turn on them, the headphones must be switched on again.

PAIRING WITH A BLUETOOTH DEVICE

1. In power Off mode, press and hold the power On button
blue light flash, there is voice "Ready to pair". The headset will enter pairing mode. (If the power
(not supplied);
(2) power On
(2) power Off button,
(2) for 3 seconds until the red and
PAG.8
X-DJ 13E80 ANC
button, voice prompt "Power On"
voice prompt "Power