Description Of Controls; Battery Charging; Turning On And Off - Trevi DJ 1265BT Manual Del Usuario

ENGLISH

DESCRIPTION OF CONTROLS

6

BATTERY CHARGING

The headphones are equipped with a rechargeable battery.
Leave the battery to charge for 6 hours upon headphones first use. When the battery is fully charged, the headphones
will last about 10 hours in music listening mode and 200 hours in standby mode.
To charge the battery:
- Connect the USB plug of the USB-DC cable provided to a device equipped with a USB port (computer, tablet, etc.)
or to an adapter featuring a 5VDC USB port (not included in the supply).
- Connect the DC plug of the USB-DC cable to the special connector (6) of the multifunction HiFi headphones. The
red led indicator (2) will on during the charging phase.
- When the battery is fully charged, the red led indicator will turn off.
Battery going flat warning:
- When the battery is almost flat, the led indicator (2) will blink twice every 30 seconds. At the same time, an inter-
mittent warning beep will be heard in the headphones.

TURNING ON AND OFF

To turn on the headset act On / Off switch (4) to position ON.
To turn off the headphones act On / Off switch (4) to OFF position.
Standby: after 10 minutes of inactivity, the HiFi headphones turn off automatically.
CONNECTION TO A BLUETOOTH DEVICE
1. Press the PLAY/PAUSE key (1) and hold it pressed until the led indicator turns on alternating red and blue light.
2. Enable the Bluetooth® connection on the external device (mobile phone, Tablet, etc.) - to do this, please refer to
the device's manual.
3. Search for the devices on the external device and select "DJ1265BT". Enter the key code "0000" if required.
4. When the connection to the external device is established, the led indicator (2) will blink.
Note 1: When the device is connected, the connection might be interrupted (e.g. when the devices connected via
Bluetooth get too far from each other). Usually, the connection is restored automatically. If this does not happen,
repeat the connection procedure from step 1 to step 4.
Note 2: Each time the headphones are to be connected to a new device, a new connection must be established and
the procedure described above must be repeated from step 1 to step 4.
Note 3: During the connection stage, the two devices must be placed within 1 m of each other. Under standard
operation, the maximum distance recommended for correct use is about 8-10 metres.
5 7 4 3
1. PLAY / PAUSE button
2. LED indicator
3. PHONE button
4. ON / OFF switch to turn on/off your headset
5. Selector Vol + / - and 9 /: button, press
and hold to adjust the volume, press once to play
the previous / next song on multimedia player.
6. 5V DC socket to recharge the headset.
7. Microphone
2 1
PAG.5
DJ 1265BT