The Charging Process - Fulbat FULLOAD 1500 Manual De Instrucciones

o If Positively Earthed – FIRST Connect the Black (-) battery charger lead to the
Negative (-) battery post and then connect the Red (+) battery charger lead to the
Vehicle's chassis and far away from the fuel line.
STEP 3 - Connect the battery charger to Mains Power (230Vac)
 Connect the battery charger to a 230VAC Mains Powered socket.
 The Charger will automatically start when AC power is connected and switched on.
(Note: If the Fault Indicator LED illuminates Red, please check your connections as it's likely that the
Positive and Negative Leads are reversed. Refer to Trouble Shooting Page for further information)

THE CHARGING PROCESS:

The charging stages and performance are as follows:
ECO Mode
If ac power is connected, and the battery is not connected, after 10 seconds, the charger will automatically go into ECO
mode, this battery charger is built with ultra-low power consumption circuit,
When Ac power is presented and battery disconnected, the power drawn is less than 0.36W, equal to power consumption
of 0.01kWh per day; after the battery is fully charged and during long term maintenance stage, the total power
consumption is around 0.03kWh per day.

The Green LED is fast flashing indicates the ECO mode.
Battery Initial Qualification
When the battery is connected and ac powers on, the program will automatically run qualification as the following
processes: - Detect the battery internal impendence and initial voltage.
- Judge the capability of charging current acceptance.
- Diagnose the battery sulphated intensity.
- Check the battery load statues and assess whether it is connected into the vehicle electronic circuit.
The program will determine the next stage subjected to above result of initial qualification.