G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE LWG 12 Documentación Técnica

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LWG
12.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine ist intended for the cutting, roughing and
brushing of metal and stone materials.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH, Trottäcker 50, D-79701 Bad Säck-
ingen, hereby declares under sole responsibility that
the product with the serial or batch no. (see reverse
side) complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
08/2017.
M. Voyame/Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Fitting of hose coupling (inside diameter min. 7
mm, available as optional accessory, item no. 908
057, type DN 8). Use oiled compressed air (see
also air quality under section 2.3). Observe national regu-
lations.
2.2 t
AKing the mAchine into serVice
2.2.1 /t
turn on urn off
16
S
oteS on afety
ommISSIonIng
Tilt lock forward an press lever onplastic sleeve. Releas-
ing the lever switches the machine OFF.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
Wheel diameter
Spindel thread
Length of spindle thread stud
No-load speed
Sound pressure level EN ISO 15744 81dB(A), K=3dB(A)
Sound power level EN ISO 15744
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 P rotection deVices
The machine may only be operated with the safety
guards and the additional handle fitted!
3.1.1 s
Afety guArd
The safety guard was already correctly adjusted in
the factory. With this adjustment it can be brought
into the desired working position, or removed.
When the pressure point is overcome the protective guard
must rotate and snap in again without the use of exces-
sive force. Otherwise, either the protective guard has to
be readjusted or the locking mechanism has to be
cleaned.
max. 6.3bar
900W
3
1.1m /min
3
0.6m /min
2-3 drops/min
max. 125mm
M14 / 5/8"
20mm
-1
12'000min
92dB(A), K=3dB(A)
2 2
7.8m/s , K=2.6m/s
3/4/4
1.700kg
/o
peratIon