Cir-Clip; Washer - LUND Rampage Products Recovery Swing Away Instrucciones De Instalación

6
Align the two "S" brackets to the pre-threaded
holes in the frame member and the bumper.
See Figure 4
7
Adjust the bumper on the vehicle. Level it side to side and front to back.
Tighten all hardware to 45 ft lbs.
Swing Away Tire Carrier Installation
8
Install plastic washer on post of the main bumper
assembly already installed on vehicle, then slide
Swing Away Tire Carrier onto post.
See Figure 5
9
Install Cir-Clip into grove at top of pivot post.
Make sure the Cir-Clip is fully seated into the
grove.
Install 3/8"-24 x 1 1/4" bolts, washers and Nylock
nuts onto tire carrier at the pivot post. Snug but
do not fully tighten at this time.
See Figure 6
NOTE: Use grease fitting on the top of post to
lubricate the swing away.
NOTE: Do not over tighten bolts as this will
restrict movement of the swing away.
NOTE: The tension of these bolts can be used
to adjust the height at the opposite side of the
swing away tire carrier. Use this adjustment to
level the swing away to the main bumper.
Figure 4
Figure 5
Figure 6
Plastic Washer
Page 3 of 6
S-Bracket

Washer

Grease Fitting
3/8" Hardware
Plastic

Cir-Clip