Removing/Installing The Metal Handle; Installing Handle; Lowering Handle For Storage; Removing Handle - RIDGID WD19560 Manual Del Usuario

SP6731-2 16 Gallon E S-v8_SP6567 16 Gallon Steel.qxd 11/21/12 3:14 PM Page 6

Removing/Installing the Metal Handle

Your Metal handle comes packaged in
the carton in the reverse direction. You
must pull the metal handle completely out
of Vac and reinstall the handle in the
correct direction, bent area facing away
from the back of the Vac, before
continuing.

Installing Handle

Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.

Lowering Handle for Storage

To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.

Removing Handle

Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).

Installing Tool Holder

Install tool holder as shown with
extension wand holders facing unit.
Tote Snaps
Correct
Position
Tote
Straps (5)
Handle
Extension
Wand
Storage
Locations
6
Metal Handle in
Reversed Position
(As Shipped)
Moving
Position
Storage
Position