Troubleshooting - Lukas P 600 OE Operación Manual

6. TROUBLESHOOTING

Fault
The motor does
not start after
pressing the main
switch
The motor runs
constantly at full
speed
Device moves
slowly when op-
erated
Connected device
does not move
when operated
Connected device
doesn't perform at
its given power
Connected device
does not reach its
end position
Check
The main switch
is not illuminated
although it has not
been switched off
Blue ring on main
switch lights up
Temperature of
device and battery
below -10°C
Battery fully
charged?
Main switch illumi-
nated?
Check device on
another power
unit
Check fill level of
the hydraulic fluid
Cause
Battery dead
Battery defective
There is a defect
in the electronics
Error in
electronics
Cold ambient
temperature
Battery dead
Battery defective
Device switched
on?
Coupling or hoses
defective
Device defective
Compact unit
defective
Solution
Charge battery
Replace battery
Repair by an
authorized dealer,
by personnel
specially trained
by LUKAS, or by
LUKAS itself
Switch off device
on the main
switch. Remove
the battery. Repair
by an authorized
dealer, by per-
sonnel specially
trained by LUKAS,
or by LUKAS itself
Use the device
normally and bring
it up to operating
temperature
Charge battery
Replace battery
Switch on device
Repair by an
authorized dealer,
by personnel
specially trained
by LUKAS, or by
LUKAS itself
Repair by an
authorized dealer,
by personnel
specially trained
by LUKAS, or by
LUKAS itself
Correct fill level
de
en
fr
es
pt
it
nl
da
sv
fi
el
pl
cs
sk
hu
ro
bg
sl
hr
et
lv
lt
zh
ko
ja
ar
23