mabe RMS1540Z Manual De Uso Y Cuidado página 100

100
frequently asked questions and operating guide
Problem
The cylinder hasn't been positioned correctly, and
the ice-trays can´t be filled with water.
Smart Fill Ice
Factory won't
You aren't giving it that extra pull to twist
release ice
the ice-tray.
The ice-tray has an excess of scale.
Water has spilt onto the lip area of the cylinder
or this has been filled to excess. Ice has been
generated, impeding the opening of the lid.
Smart Fill Ice
Factory - It has
become dif cult
The lid of the cylinder has not been properly
to open water
closed.
cylinder lid
Smart Fill Ice
The valve was obstructed by ice.
Factory - When
lling the cylinder,
water spills out
from the lower
part where the
valve is.
Ice-tray hasn´t
The programme has an in-built system to
been lled to
prevent over-filling and ice sticking.
maximum
capacity
The water cylinder wasn´t filled up to the
maximum level.
The refrigerator is resting on a sloped floor,
and/or it itself is inclined. Thus, some ice-tray
Ice cubes
cubes might not get fully filled. (The water
vary in size
cylinder has the exact volume space for
water as the ice-tray.)
The refrigerator must have a certain incline
backwards. This may cause the ice-tray to lie
slightly unevenly.
Smart Station
Freezer duct or grille obstructed.
isn't chilling
It has been installed in an unsuitable place.
Unusual Noises
The levelling is not adequate.
The accessories are not well positioned.
It has been installed in an unsuitable place.
The air circulation is obstructed.
Door is being left open for excessive amounts of time.
Refrigerator is
not cooling items
The knob on the exterior temperature display
has been incorrectly set.
Refrigerator is exposed to direct heat or sunlight.
External
Elevated humidity in the atmosphere
Condensation
(higher than 75 % RH).
External
The access door is not being closed properly.
condensation on
exterior door
(depending on
On high temperature and high humidity
model)
enviroments your refrigerator may show
condensation on the acces door.
Probable Cause What to Do
Pour water into the cylinder again. Make sure that
the cylinder has been positioned properly by
watching for water falling into the trays.
Pull the handle more firmly until completely
twisting the tray.
Clean with a soft sponge.
Clean the ice accumulation with tepid water.
Press the lid of the cylinder in the middle.
Remove ice residue, which may be near the valve,
with tepid water.
Check that the tray doesn't have ice stuck to it, or
that there isn't an excess of water.
Take out the cylinder and fill it up to maximum
capacity.
Don't add more water as this could spill out
and/or could mean more force will be required to
release the ice cubes.
The variation in size of ice cubes is normal.
Check that there aren't any objects or foods
obstructing the air-way in the freezer´s air flow
grille (grille at the front of the compartment).
See the installation instructions.
Adjust the levelling knobs.
Adapt them in accordance with instructions.
See installation instructions.
Don't allow air outlets to be obstructed.
Only open refrigerator doors for necessary time.
See operating and user guide.
See installation instructions.
It is normal for atmospheric humidity to be higher
than 75%.
Check that there aren't any objects inside the
access door keeping it from closing.
This is a normal condition in the performance
of the unit. Sweep it with a dry cloth
whenerver you feel it is needed.