Insert Hose - RIDGID 1250RV0 Manual Del Usuario

SP6961 1250RV0 A.qxp_SP6961 6/8/15 9:20 AM Page 9
Vac Drum Removal/Installation
(Continued)
5. Lower the front of the drum onto the
power base caddy and slide drum lock
lever left to right to locked position to
secure.
Note: This will allow the drum and power
base to create and maintain the proper
seal once the drum lock on the front has
been moved to the locked position. If the
drum has not been seated properly on
the power base, this lock will not engage
properly and the power switch may not
operate. This lock is located on the front
of the unit just above the power switch,
between the lower portion of the drum
and the power base.

Insert Hose

1. Insert the push button end of the
Tug-A-Long Hose into the inlet of the
Vac. The hose should snap into place.
2. To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet, as shown.
SLIDE
TO LOCK
Drum
Lock
Press ButtonThen
Push or Pull Hose
Vac Inlet
Release
Button
9