Blowing Feature - RIDGID 1250RV0 Manual Del Usuario

SP6961 1250RV0 A.qxp_SP6961 6/8/15 9:20 AM Page 13
Operation (Continued)

Blowing Feature

Your Vac features a blowing port (located
at the back of the Vac). It can blow
sawdust and other debris. Follow the
steps below to use your Vac as a blower.
1. Locate blowing port of your Vac.
2. Insert the locking end of the "Tug-A-
Long Hose into the blowing port of the
Vac. The hose should snap into place.
3. Turn Vac on and you are ready to use
your Vac as a blower.
4. To remove the hose from the Vac,
press the release button on the hose
assembly and pull the hose out of the
Vac blowing port inlet.
Blowing Port
Tug-A-Long Hose
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
WARNING: Do not leave vacuum
plugged in when not in use.
Note: When used as a vacuum, the
muffler/diffuser should be installed into
the blower port as shown. Use of the the
muffler/diffuser will help disperse the
exhaust air stream.
Release
Button
Blowing Port
Muffler/Diffuser
13
Release
Button