Silver Luxury-Lift ® Power Recliner Battery Backup Assembly Instructions - La-Z-Boy Silver Luxury-Lift Instrucciones De Operación

Silver Luxury-Lift
Glide Adjustment Instructions
WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs at
a distance to allow the legrest to fully extend without rubbing or interference.
Adjusting the Glides
Adjustable glides are provided in the front of the base to raise and level the chair as required.
Make sure to adjust the glides to a height that provides a clear path for operation of the legrest
(see Furniture Placement Guide).
Each glide is attached to the base by one jam nut and one lock washer. Loosen the jam nut.
•
Turn the glide clockwise to lower the chair or counterclockwise to raise the chair.
•
After proper adjustment, tighten the jam nut to the lock washer. Make adjustments
•
as necessary.
Repeat these steps for the other adjustable glide, if necessary.
•
10
Power Recliner
®
Lock Washer
Jam Nut
Base Glide
Silver Luxury-Lift
Battery Backup Assembly Instructions
WARNING
– To reduce the risk of serious injury:
• In the event of a power failure, the battery backup provided may not lift the user to a fully
raised position. To ensure lift functionality during a power outage, a battery backup system
must be purchased separately. Contact your La-Z-Boy
Replace the power transformer batteries every six months and after each power failure use.
Battery Backup Assembly Instructions
The performance of the built-in battery backup cannot be guaranteed. If you require continuing use
during a power outage, you should purchase a separate battery backup system. Contact your
La-Z-Boy dealer for more information.
®
The operating speed is reduced when operating on battery backup.
Always maintain constant, even pressure on the button or toggle when operating on battery backup
to reduce energy consumption.
The built-in battery backup is located in the power transformer and uses two 9-volt alkaline batteries
(not included).
1. Unplug the power transformer from the electrical outlet and disconnect the power transformer
connection at the base of the chair.
2. The battery compartment is located on the side of the power transformer. Slide the battery cover
up to access the battery compartment.
3. Place the connection caps over the battery terminals on each battery. Place the batteries in the
compartment, taking care not to damage any wires.
4. Slide the battery cover over the compartment.
5. Proceed to the Operating Instructions.
Silver Luxury-Lift Power Recliner Transformer Specifications:
®
Input: 120–240V~,50/60Hz,1.5A
Output: 29V, 2.0A
Power Recliner
®
dealer for more information.
®
Battery
Cover
(2) 9-Volt Alkaline Batteries
11