Operation Safety Guidelines - Enduro 809329 Manual Del Usuario

Remember to leave a small amount of slack cable near the motors to allow for their movement when the drive
rollers are engaged.
Use the large cable ties (27) to secure the motor cables to the motor. This ensures that there is no force and
movement on the spade connectors or movement of the cables during transit.
Route the motor cables along the underside of the caravan floor, inside the supplied convoluted trunking (11)
(this will protect the electrical cables against sharp edges and dirt) and through the drilled hole.
Secure the cable trunking (11) to the chassis or under body of the caravan by using the P-Clips (20) and screws
(19).
Once the motor cables are through the drilled hole next to the control unit (32), cut the cables, ensuring that
they are same length. Remove approx. 5mm of the insulation from the ends. Fix the spade connectors (24) by
using crimping pliers. A secure and good quality connection on each cable is essential.
Attach the spade fork connectors to the terminals on the control unit (see wiring diagram Fig. 12) and fix them
tightly by the screws. A safe and good quality connection on each cable is again essential.
Find a suitable place for the battery power isolation switch (29) which includes an external holder with hinged
cover. Important: The switch must be mounted onto the exterior body of the caravan and be easily accessible
from the outside of the caravan in case of any emergency. The switch must be mounted close to the location of
the battery in order to keep the length of the battery cables to a minimum.
Use the cardboard template to position the hole positions and then drill holes. Mount the switch and the housing
with the bolts, washers and nuts, and finally mount it on the caravan with stainless steel screws (19).
Route the positive (+) power cable from the battery to the battery power isolation switch (29) and than further
to the control unit (32).
The electronic connections of the battery power isolation switch (29) must be covered by the supplied rubber
isolation shells (33).
Route the negative (-) power cable directly to the control unit (32).
No cables may be routed over the control unit!
Again it is recommended to use the supplied trunking (11) to protect the cables against sharp edges. Attach the
trunking with P-clips (20) and P-clip screws (19).
Cut the cables to an appropriate length and remove approx. 5mm of the insulation from the ends. Fix the spade
connectors by using crimping pliers. A secure and good quality connection on each cable is essential.
Connect the battery cables to the existing battery terminals (red = positive, black = negative). Two types of
battery terminal connector (22 & 23) are provided for use as appropriate.
Caution! Make sure that you do not reverse the Positive (+) and Negative (-) connections.
Incorrect connection (reverse polarity) will result in damage to the control unit.
Finally, connect the battery cables (14 & 15) to the control unit (32). Attach the spade fork connectors to the
positive (+) and negative (-) terminal of the control box and fix them tightly by the screws.
Seal the 25mm hole in vehicle under body using plastic body sealant.
Finally find a suitable place for the remote control handset wall holder (34) and fix this by the supplied screws
(out of reach of children or other unauthorised people).
Installation of the EN
DURO
OPERATION - SAFETY GUIDELINES
Practice operating the manoeuvring system in an open area before using for the first time. This is to fully
familiarise yourself with the handset / manoeuvring system operation.
Before use, always check the caravan manoeuvring system for any damage.
When towing or moving the caravan please be aware, at all times, that ground clearance is reduced
when the manoeuvring system has been fitted.
Always ensure that children and pets are kept well out of the way during operation.
EVOLUTION caravan manoeuvring system is now complete.
®
EN
®
DURO
EVOLUTION 18
Ref: -UM-TKI-1010-Rev.A.