Assembly - RIDGID GP80145SW Manual Del Operador

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Packing
List are already assembled to your product when
you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-474-3443 for assistance.
PACKING LIST
Air Compressor
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Axle Rod
Handles (2)
Hitch Pins (2)
Lock Washers (4)
Long Screws (2)
Axle Bolts (2)
Pump Oil (SAE40)
Semi-pneumatic Tire
Short Screws (2)
Washers (4)
Spark Plug Wrench
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
INSTALLING THE HANDLES
See Figure 3, page 20.
 Insert supplied handle through handle slot.
 Slide handle forward until the hole in the handle is aligned
with the first hole in the handle slot.
 Place a washer and lock washer onto long screw. Then
install long screw through the hole in the handle.
 Place a washer and lock washer onto short screw. Then
install short screw through the second hole in the handle slot.
 Repeat handle installation on the opposite side.
REMOVING THE OIL LABEL
See Figure 4, page 20.
The air compressor has a label installed between the pump
oil cap/dipstick and the oil fill hole. Before using the unit the
first time, remove the pump oilcap/dipstick and label and
then reinsert dipstick. Make sure to add oil before first use.
See Adding/Checking Pump Oil before first time operation.
INSTALLING THE SEMI-PNEUMATIC TIRE
See Figure 5, page 20.
 Insert supplied axle rod through hole in semi-pneumatic
tire hub, centering the tire between the two center holes
in the axle rod.
 Slide hitch pins through both holes on either side of semi-
pneumatic tire to secure semi-pneumatic tire to the center
of the axle rod.
 Place tire assembly in the center of the wheel brace as
shown.
 Align the threaded holes on the tire assembly with the
holes on the left and right side of the wheel brace. Install
axle bolts through the lined up holes.
9 – English