Heath Zenith 7138 Manual Del Usuario página 2

INSTALLATION
Mounting the Solar Light Fixture (Screws):
1. Mark the screw holes on a solid surface according
to the illustration below. Install the screws (provided).
Note: Ensure the fixture and the solar panel are
located close enough together for the cord to reach.
2. Place the keyholes on the rear of fixture on the screws.
Horizontal Mount Keyhole (x2)
7.375" (187 mm)
Mounting the Solar Panel:
1. Use the screws (provided) to mount the solar panel to
a solid surface. IMPORTANT: Caulk around the base
and on top of the screw heads after installation.
2. Adjust the angle of the solar panel by moving the
adjustment support to the appropriate hook on the
mounting bracket. Remember, the solar panel must
receive as much direct sunlight over the course of
the day as possible. Keep in mind that shadows may
block the sunlight from reaching the solar panel during
the day.
3. Carefully route the solar panel cable to the light fixture.
Plug the solar panel cable into the connector extending
from the side of the battery case.
IMPORTANT: Turn the power selection switch to
the OFF position and allow the battery to charge
with 3 to 7 days of full sunshine before testing.
OPERATION
1. Allow 3 to 7 days of charging under full sunshine before
using the light for the first time.
2. Use the switch located on the bottom of the LED light
to turn the light ON/OFF. IMPORTANT: The solar panel
will not be able to keep the battery charged if the light
is left in the ON position. Leaving the light on for a
prolonged period of time could damage the battery.
2
ON/OFF Switch
206898-02