Emerson Designer CF755GRT06 Manual Del Usuario página 7

3. Ceiling Fan Assembly
3.6
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 6).
3.7
Place the Ceiling Cover over the Downrod (Figure 7).
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 7).
3.8
Route the three Motor Wires through the Hanger Ball
(Figure 8).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball (Figure 8).
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 8).
A loose Phillips Head Set Screw could create fan
wobble.
(Continued)
3.5" DOWNROD
MOTOR
HOUSING
Figure 6
Figure 7
PIN
HANGER BALL
3.5" DOWNROD
Figure 8
Please contact 1-800-654-3545 for further assistance
7
GROMMET
COUPLER
COVER
emersonfans.com
U.L. Model No.: CF755