Trox Technik X-CUBE Instrucciones De Servicio página 137

Frame / Sheets
Frame and sheets are made of seawater resistant aluminum
respectively of galvanized steel and thus, do not require
maintenance.
Storage mass
Prior to initial operation especially of vertical rotors take care
that no objects or pressing felt packings are blocking free
movement. The storage mass of the rotary heat exchanger is
made of lapped aluminum foil. In most cases and due to the
countercurrent principle self-cleaning is realized being
absolutely sufficient for the self-cleaning of the storage mass.
In case self-cleaning is insufficient the storage mass can be
periodically (dependent on the degree of soiling) cleaned with
compressed air or in case of tenacious impurities with high-
pressure cleaners (medium: purely water without chemical
admixtures).
Attention: Impinge air or water jet rectangular onto the storage
mass!
Direction of rotation
Take care that the storage mass is rotating from the exhaust air
across the cleaning sector into the supply air. This direction of
rotation of the storage mass is marked by a yellow arrrow in
the edge of the driving motor.
Attention: In case of initial operation check direction of
rotation.
V-belt
The drive V-belt is designated SPZ or SPA and is commercially
supplied with the designation "Endless V-belt". Connection is
done by flexible locks. Due to the fact that the V-belt is subject
to natural stretching which may well exceed the size of the
tensioning device it is recommended to periodically check the
tension of the V-belt. Particulary in the first 400 operating
hours. In case the drive of the storage mass can no longer be
guaranteed because the V-belt is insufficiently tensioned, the
latter has to be shortened. For simplicity of execution
this procedure does not need any explanation.
3
4
1 Rotor wheel
2 V-belt
3 V-belt pulley
4 Hinge connector
·KLINGENBURG
1
2
5
6
7
5 Motor
6 Motor frame
7 Spring
3