3.3
TARING
Manual tare
Steps:
1) Zero the scale by pressing the [Zero]/
2) Place a container on the platform, a value for its weight will be displayed.
3) Press the [Tare] ↵ key when reading is stable. The weight displayed is
then stored as the tare value.
4) The stable and "NET" indicator will show on the display.
5) Now when adding additional products, only the weight of
the current product will be shown. The scale can be tared
a second time.
Removing an object
Removing a container/ object will cause a negative value to show on the display. The zero
indicator will also appear, as the weighing platform has returned back to the same condition
as it was when the [Zero]/
The display will automatically reset to zero if removing the object causes a negative value. If
not, press [Tare] ↵ or [Zero]/
indicator will disappear.
3.4
WEIGHING
To determine the weight of a sample:
1) Zero the scale by pressing the [Zero]/
2) Place the sample onto the weighing pan. If using a container, ensure that you tare
the container before adding the sample.
3) The display will show the weight and the unit of weight currently in use.
4) To change the weighing unit press the [Units] key. The weighing units displayed are
enabled by the user in the parameters section.
© Adam Equipment Company 2019
key was pressed last.
Esc
0
to remove the tare value and display zero. The Net
Esc
0
0
8
key.
Esc
0
key
Esc