Medtronic Guardian Connect Manual De Usuario página 15

Connecting the tester for testing or cleaning
Before proceeding, have your system user guide available.
To connect the tester:
1 Hold the transmitter and the tester as shown. Line up the
flat side of the tester with the flat side of the transmitter.
2 Push the tester into the transmitter until the flexible side
arms of the tester click into the notches on both sides of the
transmitter.
When properly connected, the green light on the transmitter
flashes 6 times.
3 To test the transmitter, check the sensor icon in the app to
ensure that the transmitter is sending a signal (see your system user guide).
4 To clean the transmitter, see Cleaning the transmitter, on page 9.
5 After testing or cleaning, disconnect the tester from the transmitter.
Disconnecting the tester
To disconnect the tester:
1 Hold the transmitter body as shown and pinch the side
arms of the tester.
2 With the tester arms pinched, gently pull the transmitter
away from the tester.
Note: To save transmitter battery life, do NOT leave the
tester connected after cleaning or testing.
Cleaning the transmitter
The transmitter is intended for personal use at home (single-patient use) or for use in
healthcare facilities (multiple-patient use). Single-patient use requires cleaning after
each use, while multiple-patient use requires cleaning and disinfection after each
use. When using the transmitter in a healthcare facility, always follow the cleaning
and disinfecting procedure for multiple-patient use.
Warning: Do not discard the transmitter in a medical waste container or
expose it to extreme heat. The transmitter contains a battery that
may ignite, and result in serious injury.
Note: The tester is a required component for cleaning the transmitter. For details,
see Tester, on page 7.
-9-