40 seconds, you will hear a tone. Press any key to continue.
This remote access feature enables you to call your home and turn ON
the answering machine's microphone function, allowing you to monitor
sounds in the room where the answering machine is situated.
turning the answering machine on from a
The answering machine can be activated using the remote control
functions.
1 Call up the answering machine. After approximately 10 rings, the
machine will answer and emit a long tone.
2 Enter the remote code, printed underneath the unit. If the code is
accepted, you will hear two short beeps.
3 Press 9#. Two beeps confirms that the answering machine is now
on. replace the handset.
The total capacity of the answering machine's memory is
approximately 14 minutes.
The memory space is shared between the outgoing message,
personal memos, and regular incoming messages.
When the memory is full the display will show FL, the answering
machine will answer after 10 rings to allow remote playback and
deletion of messages, no new messages will be accepted until the
existing messages have been played and erased.
This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of this equipment
is a label that contains, among other information, a product identifier
in the format US: AAAEQ##TXXXX. If requested, this number must
be provided to the telephone company. an applicable certification
jacks Universal Service Order Codes (USOC) for the equipment is
provided (i.e., RJ11C) in the packaging with each piece of approved
terminal equipment
The REN is useful to determine the quantity of devices you may
connect to your telephone line and still have all of those devices ring
when your telephone number is called. In most, but not all areas,
the sum of the rEN's of all devices connected to one line should not
exceed five (5.0). To be certain of the number of devices you may
room Monitoring
remote location
out of Memory
fcc WantS YoU to KnoW
12 – ENGLISH