Fagor Duo Manual De Uso página 30

Vuelve al hogar
washing up liquid, rinse and dry. To ensure
correct cooker tightness, the silicone seal
should be changed every 12-18 months de-
pending on frequency of use. We recom-
mend replacing the safety valve silicone seal
with the same frequency.
6. Don't store cooker with the lid on. Only
place lid upside down on the pressure cooker.
Thus, eliminating the risk of creating a vacuum
inside when not in use, which would hinder sub-
sequent cooker opening. This also prevents
bad smells forming inside.
7. Prior to opening the Fagor pressure
cooker, always check the handles (cooker,
side and lid handles) are correctly screwed
into place. Otherwise, use a screwdriver to
tighten the screws.
8. Spare parts: Use only original spares. Use of
unauthorised parts or adherences may cause
malfunction of the unit and cancel any guaran-
tee protection provided by the manufacturer.
Operating valve cleaning
Check the operating valve after each use to
check there are no food remains inside it.
To do this, move valve to position shown in
figure 10 remove the valve (detailed instruc-
tions below). Clean it by letting water run
through it. Next, holding the lid against the
light, look through the hole below the valve
to make sure no food particle is obstructing
it. If necessary clean the hole with a small
brush. If having checked the valve, you note
the cooker doesn't function properly, don't
use under any circumstance but take it to
the Authorised Technical Service.
30 INSTRUCTION MANUAL
How to remove the operating
valve for cleaning
1. Place valve in steam expulsion position,
steam cloud picture (Fig.10).
2. Carefully pull the valve upwards
(Fig. 15).
3. On lifting the valve, trying moving it anti-
clockwise to the circle crossed by a line. You'll
see a groove and once the valve reaches it
you'll be able to turn it completely to opening
position, a circle crossed by a line (Fig.16).
4. Remove valve pulling upwards and clean
as instructed above in this section.
How to replace it after cleaning
Turn valve towards the opening position
(Fig.11), put valve back into place turning it
clockwise towards the steam expulsion po-
sition. You will hear a click when the valve
moves back into place.
Fig.10
Fig.16
Fig.15
Fig.11