Installation And Start-Up; Technical Specifications - Tripp-Lite APS1012SW Manual Del Propietário

4. Installation and Operation

4.3 Installation and Start-Up

4.3.1
Connect the unit to the batteries per Section 3. Ensure that the nominal DC battery voltage is 12V.
4.3.2
Connect the unit to the AC load. Then, connect to the AC source. Confirm all wiring is correct and terminal is tight.
4.3.3
Press the ON/OFF button. The system will start working after a few seconds. If the AC source power fails, the unit will work in
Inverter mode. Otherwise, the system will switch to AC Mode and will power the load while charging the battery.

5. Technical Specifications

Specification
Continuous Power
Peak Inverter Efficiency
Output Waveform
DC Current at Rated Power
Recommended Battery Fuse
Nominal Input Voltage
DC Input Voltage Range
Low Battery Protection (Heavy/Light Load)
DC Mode Output Voltage Regulation
Power Factor Allowed
Frequency Regulation
Standard Output Voltage
Load Sensing (Power Saving)
Transfer Time
Forced Air Cooling
Automatic Transfer Relay
Adjustable Charge current
Resistive Load
Inductive Load
Motor Load
Rectifier Load
Wall-Mounting
Model
APS1012SW
1000 Watts
120 Amps
200 Amps
10.0 ~ 16 VDC
10.9/11.2 VDC
50/60 Hz +/- 0.5 Hz (Autoselect)
16 ms, maximum
Variable Speed
15A
4 ~ 40 A
11
APS2012SW
2000 Watts
>79%
Sine Wave
250 Amps
400 Amps
12 VDC
+/- 10%
0.8 to 1
120 VAC
100 W
30A
6 ~ 60A
100%
YES
YES
YES
YES