Operation - Craftsman CMXGWAS020727 Manual Del Operario

Operation

How to Start Your Electric Pressure Washer
Follow the instructions below in the order presented. If
you have any problems operating your electric pressure
washer, please call the electric pressure washer helpline at
(888) 331-4569.
WARNING Risk of eye injury. Spray could splash
back or propel objects resulting in serious
injury. Always wear indirect vented (chemical
splash) safety goggles marked to comply with
ANSI Z87.1 when using or in vicinity of this equipment.
NEVER substitute safety glasses or dry-condition
goggles for indirect vented safety goggles.
1. Place the electric pressure washer near an outside
water source capable of supplying water at a flow
rate greater than 5.0 gallons per minute (18.9 l) and
25-75 psi (1.72-5.17 bar) at the electric pressure
washer end of garden hose. DO NOT siphon supply
water.
2. Connect garden hose to water inlet.
3. Check that high pressure hose is tightly connected to spray
gun and high pressure outlet. See Assembly section.
NOTICE If hose connections start leaking during use,
shut down unit as described in steps 1-5 of How to Stop
Your Electric Pressure Washer. Remove hose completely
and reinstall hand tight. Failure to completely remove
hose could damage o-ring and cause hose connection to
continue leaking. If o-ring becomes damaged, replace.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
4. Turn ON water, point gun in a safe direction, press
trigger lock button and squeeze trigger to purge pump
system of air.
5. Install spray wand and 7-in-1 nozzle onto spray gun.
See Assembly section.
NOTICE The unit can be operated in vertical or horizontal
positions.
6. Turn master ON/OFF switch (A) to OFF (0) position.
A
WARNING Risk of electrocution. Use of an extension
cord could cause electric shock or burn
resulting in death or serious injury.
• DO NOT use an extension cord with this electric
pressure washer. Your home's electrical circuit
receptacle or extension cord may not provide lifesaving
ground-fault circuit-interruption protection.
7. Plug electrical power cord into a dedicated electrical
circuit rated for 120 Volts AC at 15 Amps that is
properly installed in accordance with all local codes
and ordinances. Circuit is not to supply any other
electrical needs. The indicator light on the GFCI
should be ON.
NOTICE The indicator light must be ON for the electric
pressure washer to operate.
WARNING Risk of electrocution. Non-operating
ground fault circuit interrupter (GFCI) could
result in death or bodily injury. If indicator light
does not stay ON after test and reset, do not
use GFCI.
8. Press TEST button (B). The indicator light (C) should
be OFF.
D
B
C
9. Press RESET button (D). The indicator light (C) should
be ON.
NOTICE DO NOT use the electric pressure washer if above
test fails.
10. Turn master ON/OFF switch to ON (I) position.
11. Point gun in a safe direction, press trigger lock button
and squeeze trigger.
The electric pressure washer motor will start and stop as
spray gun trigger is depressed and released.
9