Craftsman CMXGWAS020727 Manual Del Operario página 10

The electric pressure washer is now ready for use.
Instructions for use of the supplied accessories are given
later in this section.
How to Stop Your Electric Pressure Washer
The electric pressure washer motor runs only when the
trigger is engaged. To stop the electric pressure washer
and turn off the motor:
1. Release spray gun trigger.
2. Turn master ON/OFF switch to OFF (0) position.
NOTICE Releasing the trigger will shut off the motor but
does not shut off electrical power to the unit.
3. Turn off water supply.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when motor
is stopped and water is disconnected, which could
result in serious injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point spray gun in safe direction, squeeze
spray gun trigger to release high pressure, every time
you turn off pressure washer.
4. ALWAYS point spray gun in a safe direction, press
trigger lock button and squeeze trigger to relieve built
up pressure in the unit.
5. Disconnect GFCI plug from outlet.
How to Use Nozzles
7-in-1 Nozzle
The 7-in-1 nozzle allows you to switch between seven
different spray pattern nozzles. Release trigger on spray
gun to engage safety lock before changing spray patterns.
The spray patterns vary as shown below.
High Pressure Mode
0˚ 15˚
Maximum General
10
1. Select desired spray pattern:
2. Turn dial until desired spray pattern lines up with
Red High Pressure Nozzle
The red high pressure nozzle gives you the most cleaning
power by producing the highest pressure.
Usage Tips
40˚
Gentle Fan Spray
• Select Maximum 0° nozzle setting for stubborn or
hard to reach surface such as second story surfaces,
paint removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax, etc.).
• Select General 15° nozzle setting for tougher
cleaning tasks. Ideal for removing grease and dirt
from hard surfaces. Also capable of stripping paint
when held at a 45° angle.
• Select Gentle 40° nozzle setting for gentle
cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc.
• Select Fan Spray nozzle setting for optimal high
flow rinsing away of light dirt and debris.
• Select Fan Spray with Soap nozzle setting for
delicate surface cleaning of cars, trucks, childrens
play equipment, patio furniture, etc.
• Select Extended Reach nozzle setting for quick
high flow clean up and long reach cleaning of
second story siding and windows.
• Select Extended Reach with Soap nozzle setting to
propell soap to second story siding and windows.
arrow on 7-in-1 nozzle.
• For most effective cleaning, keep nozzle from 8 to
24 inches away from cleaning surface.
• If you get too close, especially using a high pressure
spray pattern nozzle, you may damage surface being
cleaned.
• Do Not get closer than 6 inches (15 cm) when
cleaning tires.
High Flow Mode
Fan Spray Extended Reach
with Soap
Extended Reach
with Soap
Craftsman.com