Kohler K-T314 Instrucciones Para La Instalación página 8

6. BEFORE INSTALLING SPOUT AND HANDLES
REMOVE PIPE PLUG
Ensure that the valves are closed (cold - fully
counterclockwise, hot - fully clockwise).
Turn off the main water supply.
WARNING: Risk of personal injury. Lines may be
pressurized. Do not lean over pipe plug when
turning or removing the plug.
Wrap a towel around the pipe plug to prevent water spray.
Water may purge from the supply tube when you remove
the plug.
Carefully remove the pipe plug.
7. INSTALL SPOUT
Remove the plaster guard from the spout supply tube.
Cut off the spout supply tube 1-1/4" (3.2cm) above the rim,
finished deck, or tile.
Ensure that all burrs are removed from the supply tube to
prevent damage to the O-ring seal on the sleeve.
NOTE: The following step is applicable to a tile covered
rough deck installation only.
Slide a brass washer, flat side facing forward, onto the
supply tube. The brass washer is furnished with the spout.
NOTE: The washer is not needed for rim/finished deck
installation.
A
1012557-2-
1/4" Pipe Plug
Close
Hot
Washer
Spout
Supply
Tube
8
Close
Cold
Fig. #15
1-1/4" (3.2cm)
Tile
Finish
Rough
Deck
Fig. #16
Finished
Deck
Rough
Deck
Fig. #17
Kohler Co., Kohler, WI U.S.A.