Blumfeldt 10035366 Manual Del Usuario página 27

CONNECTING TO A GAS CYLINDER
• Use a 10 kg gas cylinder. Please refer to your gas supplier for suitable gas
cylinder.
• The maximum diameter and the maximum height of the cylinder is
330 mm and 500 mm.
• Refer to your gas supplier for instructions on the use of your gas cylinder.
• Only change gas cylinders outdoors or in a well ventilated area away from
naked flames and any other source of ignition.
• The gas cylinder must always be used in an upright position.
• Close the appliance control knob by turning fully clockwise.
• Close the gas cylinder tap and then attach the regulator onto the gas
cylinder.
• Tighten all connections firmly and with a spanner where appropriate. The
cylinder should be located on the cylinder base.
• Check for leaks at all joints using soapy water. If a leak is found, tighten
the joint and then re-test
WARNING
Danger of Explosion
Never use a naked flame to check for leaks.
NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
NEVER LEAK TEST WHILE SMOKING.
The gas connections on this appliance are leak tested at the factory prior to
shipment.
This appliance needs to be periodically checked for leaks and an immediate
check is required if the smell of gas is detected.
• Make a soap solution using 1 part of liquid dish-washing soap to 3 parts
water. The soap solution can be applied with a soap bottle, brush, or rag
to the leak tested points shown in the figure above.
• The valve of the gas cylinder should be in the OFF position at this point of
the leak test. Once the soapy solution is applied to the gas connections,
the valve of the gas cylinder needs to be turned to the ON position.
• Soap bubbles will begin to form in the soapy solution if a leak is present.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then
turn the gas supply on and recheck.
EN
27