EN
Danger of Electric Shock from Water
• Use and store the device only in closed rooms. Do not operate the device in rooms with
high humidity.
• Never immerse the motor unit, mains cable or mains plug in water or other liquids and ensure
that they cannot fall into water or become wet.
• Should the motor unit fall into water, switch off the power supply immediately. Do not attempt to
pull the device out of the water while it is still connected to the mains power! Have the device
checked in a specialist workshop before using it again.
• Never touch the device, mains cable or mains plug with wet hands when these components are
connected to the mains power.
Warning of Electric Shock from Damage and Inappropriate Use
• The device should only be connected to a properly installed socket with safety contacts.
The socket must also be readily accessible after connection so that the connection to the
mains can quickly be isolated. The mains voltage must match the technical data of the device. Only
use suitable extension cables whose technical data is the same as that of the device.
• The device must be switched off when inserting or removing the mains plug.
• Remove the mains plug if a fault occurs during operation or before a thunderstorm.
Warning of Fire
• Do not use the device in rooms containing easily ignitable or explosive substances.
• Do not operate the device in the vicinity of combustible material. Do not place any
combustible materials (e. g. cardboard, paper or plastic) on or in the device.
• Do not connect the device along with other consumers (with a high wattage) to a multiple socket
in order to prevent overloading and a possible short circuit (fire).
• Do not cover the device during operation in order to prevent it from catching fire. Do not insert
anything into the ventilation openings of the device and make sure that these do not become
clogged.
• In the event of a fire: Do not extinguish with water! Smother the flames with a fire blanket or a
suitable fire extinguisher.
Risk of Damage to Material and Property
• Always check the device for damage before putting it into operation. The device should
only be used when it is fully assembled, undamaged, and in working order!
• Always place the device on a dry, even, firm and heat-resistant surface. Do not place it below
kitchen wall units or similar cupboards. The rising steam could cause damage to them!
• Do not place the device on or next to heat sources such as hobs or ovens. Keep naked flames,
e.g. burning candles, away from the device, the cable and the plug.
• The device may not be heated up when it is empty. Do not allow the motor to run when the
device is empty.
• Make sure that the maximum fill level (MAX marking in the mixing bowl) is not exceeded!
• Make sure that the mains cable is not squashed, bent or laid over sharp edges and does not
come into contact with hot surfaces (this also applies to the hot surfaces of the device!).
• Do not move the device during use.
• When the mains plug is removed from the plug socket, always pull on the mains plug and never
the cable.
• Do not pull or carry the device by the mains cable.
• Use only original spare parts from the manufacturer.
• Never place heavy objects on the device.
02
• Do not expose the device to extreme temperatures, strong temperature fluctuations, moisture,
direct sunlight or impacts.
ITEMS SUPPLIED AND DEVICE OVERVIEW
Unpack all parts and check the items supplied for completeness and any transport damage. If you
find any damage to the components, do not (!) use the device, but contact our customer service
department.
Steaming bowl lid
Steaming rack
Steaming bowl
(with sealing ring)
Mixing bowl
Mixing bowl mount
Motor unit
Suction feet
BEFORE INITIAL USE
1. Remove any protective films and stickers that may be present from the device.
2. The accessories may still have some production residues on them. To avoid harmful effects to
your health, clean the device thoroughly before you first use it (see "Cleaning and Storage").
3. Familiarize yourself with the accessories. Do this by reading the following chapter.
Measuring cup (max.50ml)
Mixing bowl lid
(with sealing ring)
Cross-blade
attachment
Blade cover
Butterfly whisk
Digital scale
Power button
Control panel
On/Off switch
(on the back)
Mixing jug release button
03
EN