Remote Controller - Haier HSU-07HV03/R2DB Manual De Funcionamiento

Operation
HEALTH operation

Remote controller

FRESH
STERILIZE
Note:
(1)when the unit is operating
health or sterilize function," "
displayed on the display board
and " " is displayed on the
di splay board in the fresh
function.
(2) The buttons and the functions of
FRESH and STERILIZE are only for
the units of HSU-09HV03/R2(SBD)
and HSU-12HV03/R2(SBD).
(3) The buttons and the functions of
Power/Soft are only for the units of
HSU-07$09$12$18HV03/R2(BD).
(4) When using the HEALTH/STERILIZE
function, the backlight is green;
When using the FRESH function,
the backlight is yellowish green;
If using the HEALTH/STERILIZE and
FRESH functions at the same time,
the color is the last one.
1.Unit start
Press ON/OFF on the remote controller, unit starts.
Health function includes health anion function, UV light
degerming function and change-for-fresh-air function.
2.Health anion function
Press HEALTH button. For each press,
Air conditioner starts health anion function operation.
For twice press, disappears,the operation stops.
3.UV light degerming function
Press STERILIZE button ,"
controller and the air conditioning starts the UV light degerming
function.
" ": For timing operation of UV light degerming function and
automatically canceled after 30 minutes' operation.
" ": For the long-time running of UV light degerming function.
No display: For UV light degerming function not starting.
4.Change-for-fresh-air function
Press FRESH button , " "displayed on the remote
controller and the change-for-fresh-air function operation begins.
For twice press , the display " "disappears and the
change-for-fresh-air function operation is canceled
When indoor fan motor is running, it has healthy
process function. (It's available under any mode)
When the fan in the indoor unit does not work, the health lamp
lights up, but the anion generator does not release anion.
BRIEF INTRODUCTION TO HEALTH ANION FUCTION
The anion generator in the air conditioner can generate a lot of
anion effectively balance the quantity of position and anion in the
air and also to kill bacteria and speed up the dust sediment in
the room and finally clean the air in the room.
About UV light degerming function
UV light emitted by the UV light device of the indoor unit catalytically
activates the nano TiO on the multi-lights touching intermediary,
2
and the degerming effect is highly efficient and lasting.
Note: when the function is running, don't open the inlet grille.
About change-for-fresh-air function
1.After the change-for-fresh-air function is initiated, the outside air can
enter the indoors through the change-for-fresh-air tube thereby
keeping the indoor air fresh.
2.Setting the change-for-fresh-air function under the shutdown status:
Under shutdown status, press the new wind key and the remote
controller displays the on status of air flow, low wind, and change-
for-fresh-air functions, and now can set the timing open, timing
close and time control switch. Press on-off button to cancel the
change-for-fresh-air function.
10
is displayed.
"and " "displayed on the remote