Control Panel; Remote Control - Haier QHNE06AA Manual Del Propietario Y Instrucciones De Instalación

CONTROL PANEL

Features and appearance will vary.
Lights below the touch pads on the air conditioner control panel indicate the selected settings.
2
4
5
3
7
1
Air Conditioner Controls
Cont rols
ower Pad
1. P
Turns air conditioner on and off. When turned on, the
display will show the Set temperature.
isplay
2. D
Shows the Set temperature or time remaining on the
Delay timer. Shows the Set temperature while setting the
temperature in Cool or ECO modes.
emp and Delay Increase
3. T
Use to set temperature or delay time. Temperature can be
set in Cool and Energy Saving mode.
ode Pad
4. M
Use to set the air conditioner to Fan Only, Cool, or ECO
mode.
an Speed Pad
5. F
In Cool, Energy Saving mode:
Use to set the fan speed to Auto, High, Med or Low on the
unit.
In Fan Only mode:
Use to set the fan speed to High, Med, or Low
on the unit.
6
6
Fan Mode Delay
Cool On
Auto
High Fan
Mid Eco
Low
Temp/Time
Filter
Reset
/ Decrease Pads
^ v
1
5
Speed
4
Mode

Remote Control

elay Pad
6. D
Delay ON— When the air conditioner is off, it can be set
to automatically come on in 1 to 24 hours at its previous
mode and fan settings.
Delay OFF— When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the remote
control. Each touch of the Increase
the unit or the remote control will set the timer in 1-hour
intervals.
To review the remaining time on the Delay 1–24hr timer,
press the Delay 1–24hr pad on the unit or the remote
control. Use the Increase
or on the remote control to set a new time if desired.
To cancel the timer, press Decrease v pad on the unit
or the remote control until the set time is zero. After 3
seconds the light on the Delay 1- 24 hour pad goes off .
7. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after 250
hours of operation. Clean the air filter (refer to page 9),
place it back in the front panel, and press the Filter Reset
pad. The light will go off.
Power
3
6
Eco
Delay
^
/ Decrease v pads on
^
/ Decrease v pads on the unit
49- 5000540 Rev. 2