Install The Handles - Kohler STERLING 6300 Serie Guia De Instalacion

Wall Jamb
Cover
Wall Jamb
Inside Handle
Spacer
Outside
Hole
Handle
Handle
Logo Setscrew
Spacer

10. Install the Handles

CAUTION: Risk of product damage. If the handles are tightened to the tempered glass without the
spacers the glass will shatter. When reassembling the door handle assembly, it is critical the
provided spacers be re-installed. Without the spacers there will be metal-on-glass contact.
Install the wall jamb covers to the top of the wall jambs. Flat edges should be toward the wall.
NOTE: The handle comes pre-assembled and must be disassembled prior to installation on the shower
door.
Unscrew handle with no logo from the pre-assembled handle assembly.
Remove the spacer from the handle setscrew.
Slide the assembled handle setscrew and handle assembly (logo facing the outside of the shower)
through the hole in the glass shower door.
Reinstall the spacer on the handle setscrew.
Screw the other non-logo handle onto the handle setscrew.
Fully tighten both handles evenly making sure the logo is properly orientated.
11. Seal the Shower Door
IMPORTANT! Carefully follow the silicone sealant manufacturer's instructions for application and curing
time.
NOTE: Thoroughly clean and dry dust, dirt, and grease from the bottom track and shower door ledge
surface where silicone sealant will be applied.
Apply silicone sealant to the outside and inside of the shower where the wall jambs meet the walls.
1019156-2-H
Apply sealant.
Apply sealant.
Wall Jamb
Cover
Apply
sealant.
Apply
sealant.
14
Apply
sealant.
Apply
sealant.
Sterling