• Do not force any part of your body, in particular your fingers, between the rotating massage heads and
their mountings in the device.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer
can over-stimulate the muscles and cause tension instead of relaxation.
Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.
8. Care and storage
Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Clean the instrument with a slightly moistened cloth. You can also moisten the cloth with mild soap
suds to remove more stubborn dirt.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
9. In the event of problems
Problem
Massage heads
rotating at
reduced speed.
Massage heads
not moving.
10. Disposal
CAUTION
For environmental reasons, do not dispose of the device in the household waste at the end
of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in
accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
11. Technical data
Supply:
Dimensions:
Weight:
Cause
The load on the massage
heads is too great.
Appliance not connected to
the power supply.
220-240 V~, 50/60 Hz, 50 W
36.5 x 41.0 x 11.0 cm
approx. 3 kg
Remedy
Release the massage heads.
Connect the mains plug and switch on the device.
Set the main switch to 1.
12