Cebora SYNSTAR 400 TS Manual De Instrucciones página 36

To move the power source, fit the missing rear wheels and adhere scrupulously to the following instructions.
Disconnect the device from the power supply before moving it.
During transport of the device, ensure that all applicable local accident prevention guidelines and regulations are
observed.
After transport or relocation and before operating, a visual inspection must be performed on the device to check for
any damage.
Ensure any damage is repaired by qualified CEBORA authorised technical assistance staff before operating the device.
The capacity of the lifting device must be at least 20% greater than that of the load to be lifted.
When lifting the power source and the wire feeder, use only the eyebolts located on the top of the power source and
on the wire feeder spool support.
All harnessing devices (straps, buckles, chains, etc.) that are used together with the device or its components must
be checked at regular intervals
(e.g. for mechanical damage, corrosion or alterations caused by environmental factors). Check intervals and scope
must at least comply with national standards and directives in force from time to time.
Position the welding machine so as to allow the free circulation of air inside and, as much as possible, prevent metal
or other dusts from entering.
The machine must be installed by professional personnel. All connections must be carried out according to current
regulations, and in full compliance with safety laws in the country where the device is used.
Carefully read the "Mains connection" section in General Warnings code 3301151.
The installation and management of this system must comply with the CEI EN 60974-9 standard.
Make sure that the mains voltage matches the voltage indicated on the specifications plate of the power
source�
Connect a plug of adequate capacity for the current consumption I1 indicated on the data plate.
Make sure that the yellow/green conductor of the power cable is connected to the plug's earth contact.
The capacity of the overload cut-out switch or fuses, positioned between the power supply network and the power
source, must be adequate for current I1 consumed by the power source.
It is essential to use the device only if connected to a power supply with an earth conductor.
Using the device connected to the mains without an earth conductor or to a socket without a contact for this conductor
constitutes very serious negligence.
The manufacturer declines all responsibility for damage to people or property resulting from incorrect connection to
the mains.
The user is bound to have the efficiency of the earth conductor of the system and the device in use periodically
checked by a qualified electrician.
36/58
WARNING
CAUTION
NOTICE
WARNING
DANGER