Door Removal, Leveling And Alignment - Whirlpool WRS49 Serie Instrucciones De Uso

IMPORTANT: We recommend that the door removal operation
must be done by a qualified service technician.
Gather the required tools and parts and read all instructions
before starting installation. Save these instructions for future
reference.
IMPORTANT: The graphics on this page are for models with the
ice storage bin on the door. On models with the ice storage bin
inside the freezer, the wiring and water dispenser tubing
configurations are simpler than what is shown in these graphics.
Please read all instructions on the next few pages for more
information.
NOTE: Before moving your product into your home, measure the
doorway of your home to see whether you need to remove the
refrigerator and freezer doors. If door removal is necessary, see
the instructions below.
Freezer door
1 2
4
3
Use screwdriver to unscrew
1
3 setscrews and take down
the top hinge, as shown in
the figure.

Door removal, leveling and alignment

6 7
5 8
IMPORTANT: Before you begin, turn the refrigerator control OFF
or turn cooling off. Unplug refrigerator or disconnect power.
Remove food, the ice storage bin (on some models), and any
adjustable door or utility bins from doors.
Electrical Shock Hazard
Disconnect power before removing doors.
Failure to do so can result in death or electrical shock.
2 Dismantle 4 terminals
manually, use cross
screwdriver or socket
wrench to disengage 2
M5 screws and
grounding screw
counterclockwise, and
take down the top
hinge after the
dismantlement.
Note: You should ensure that the cooler door is fitting to
the cabinet before dismantling the top hinge screws, or
there exists the hidden danger of door falling.
Use cross screwdriver to
3
disengage the fastening
screws of bottom beam
cover counterclockwise
Then, pull out the bottom
beam cover.
Take down the spacing
4
washers at both ends of
coupler connector as shown
in the red circle, and then pull
out the water pipe by
simultaneously jamming both
ends of coupler connector
(for models equipped with).
5
Lift the freezer door upward
to separate the bottom hinge
shaft from door axle hole,
take down the door and
place it at an appropriate
position.
6
1