Stand-Alone Operation - Velleman VDPLW1308 Manual Del Usuario

• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation and Use of the VDPLW1308
a. Setup
Connect the spots using the supplied DC/signal cables
and set each fixture address as illustrated.
b. Front and Side Panel Functions
c. Stand-alone Operation
• Press the MODE button to view the chase menu
Select chases 1-9 using the UP and DOWN buttons.
Chase 1-8 run according to the fade and speed values.
Chase 9 is SOUND-active.
VDPLW1308
DMX mode (1 – 512)
DMX address selection
for Pixel Drive 80
Stand-alone mode
1 – 8 = auto Chase
9 = sound chase
Fixture control mode
Select mode 1, 2, 4 or 8
Manual RGB colour mixing
Press F/S to begin
Use UP / DOWN to adjust
Adjust the chase fading time
from 0 -100%
Adjust the chase speed
from 0 – 500/min
2
DMX512 output
DMX512 input
Microphone
Audio level
Power cord
Fuse
Power ON/OFF
VELLEMAN