Bestop 77332 Manual Del Usario página 9

Section 4
Install Rubber Pads in Rear & MIddle Clamps; Attach Lower Clamps
Step 1 720035
Rear Clamp
Middle Clamp
Step 1
Attach two (2) Rubber Pads #720035 together,
and stick them to the Rear and Middle Rail
Clamps, between the rib farthest from the rail,
and the next rib, as shown.
The rubber pads must rest on top of the bed
rail cap after installation.
The Rear Clamps should be located 10.0" from
the end of each Rear Side Rail.
Slide each Middle Clamp forward until it hits
the side rail coupler.
NOTE:
Make sure that the Rubber Pads are
lined up on top of the vehicle's bed rail cap.
P9 - 77332 Rev. C 1219
Hardware
Rubber Pad
Part #720035
Qty. 8
10.0"
10"
Lower Clamp
Part #579.23
Qty. 6
Hex Head Bolt
Part #578.39
Qty. 6
Tools
Torque Wrench
Installation Instructions - Supertop for Trucks
Page 9
Step 2 579.23 578.39
1
Step 2
1 Attach Lower Clamps #579.23 to all
six (6) pre-assembled Upper Clamps on
the Side Rails, using one (1) Hex Head
Bolt #578.39 for each clamp.
Check alignment of the Rail Assembly
and tighten all bolts.
Tighten all bolts to 55 in-lbs torque.
© 2019 Bestop, Inc.