Bestop 77332 Manual Del Usario página 8

Section 3
Adjust Rails; Install Rubber Pads in Front Rail Clamps
Step 1 Rail Assembly
Step 1
Adjust the Side and Front and Rear
Rail assembly right-to-left to center it
on the bed width.
P8 - 77332 Rev. C 1219
Hardware
Rubber Pad
Part #720035
Qty. 4
Installation Instructions - Supertop for Trucks
Step 2 720035
7.0"
9.75"
1
Step 2
1 Attach two (2) Rubber Pads #720035
together, and stick them to the Front Rail
Clamp, between the rib farthest from the
rail, and the next rib.
The rubber pads must rest on top of the
bed rail cap after installation.
Front Clamp should be located 7.0" from
the end of the Front Side Rail.
2 Make two cuts in the seal on the
bottom of the front rail, in line with the inner
edge of the bed rail cap, so that the seal will
lay flat against the bed bulkhead.
Page 8
Make a cut in
the seal here,
on both ends
of the front rail
2
© 2019 Bestop, Inc.