Checking And Replacing The Carbon Brushes; General Maintenance & Cleaning; Environmental Protection - Evolution F165 CCSL Instrucciones Originales

Fig. 16
Fig. 18
www.evolutionpowertools.com
CHECKING AND REPLACING
(19)
THE CARBON BRUSHES
WARNING: Disconnect the machine from the power supply
before attempting to check or replace the Carbon Brushes.
Note: Replace both carbon brushes if either has less than 6mm.
length of carbon remaining, or if the spring or wire is damaged
or burned.
To remove the brushes:
• Unscrew the plastic caps found at the back of the motor
housing. (Fig. 18) Be careful as the caps are spring-loaded.
• Withdraw the brushes with their springs.
• If replacement is necessary renew the brushes and replace
the caps.
Note: Used but serviceable brushes can be replaced, but only as
long as they are returned to the same position, and
inserted the same way round as they were before being removed
from the machine.
• Run machines motor without load for approximately 5
minutes. This will help the new brushes to 'bed-in' and ensure
that the motor runs efficiently.
• Some sparking may be visible until the brushes bed in fully.
GENERAL MAINTENANCE & CLEANING
(20)
Note: All maintenance must be carried out with the machine
switched off and disconnected from the power supply.
• Check that all safety features and guards are operating
correctly on a regular basis. Only use this machine if all
guards/safety features are fully operational.
• All motor bearings in these machines are lubricated for life. No
further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
Remove any dust or other contaminants from the lens cover of
the LED module.
WARNING: Do not attempt to clean by inserting pointed objects
through openings in the machines casings etc. The machines air
vents should be cleaned using compressed dry air.
Note: The operator should employ all necessary PPE when using
compressed dry air as a cleaning medium.

ENVIRONMENTAL PROTECTION

(21)
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice.
16