Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.evolutionpowertools.com
If a very precise bevel angle is required, then the blade setting
should be checked using a vernier angle gauge (not supplied)
and adjusted accordingly.
• Loosen the Bevel Locking Mechanism found at the front of the
machine, by pulling the lever upwards. (Fig. 13)
• Tilt the blade to the required angle as indicated on the
quadrant protractor scale. (Fig. 14)
• Tighten the Bevel Locking Mechanism securely when
the desired bevel angle has been achieved by pushing the
lever downwards.
OPERATING ADVICE
(14)
(PRE OPERATION CHECKS)
Note: As all operating environments will be unique and diverse,
Evolution Power Tools offers the following general advice on safe
operational procedures and practices for the consideration of the
operator.
This advice cannot be exhaustive as Evolution has no influence
on the type of workshops or working environments in which
these machines may be used.
We recommend that the operator seeks advice from a competent
authority or the workshop supervisor if they are at unsure of any
aspect of using these machines.
It is important that routine safety checks are carried out (at each
time of usage) before the operator uses the machine.
WARNING: These pre-use safety checks should be carried out
with the machine disconnected from the mains power supply.
• Check that all safety guards are operating correctly, and that
all adjustment handles/screws are securely tightened.
• Check that the blade is secure and installed correctly. Also
check that it is the correct blade for the material being cut.
•
Check the integrity of the power cord.
• Whenever possible clamp the workpiece to a rigid support
structure such as a workbench, saw horse or similar.
•
he operator should always be aware of the position and
routing of the power cable.
PPE
(15)
•
The operator should wear all relevant PPE (Personal Protection
Equipment) necessary for the task ahead. This could include
safety glasses,,full face mask, dust masks, safety shoes etc.
Fig. 13
Fig. 14
13
EN
Tabla de contenido
