Yakima HoldUp Plus2 Manual De Instrucciones página 2

remove end cap
from holdup.
Using a flathead screwdriver, remove
the end cap from the holdUp.
Install maIn Bolt.
attach fIrst traY to Base.
Align holes in base to holes in tray.
• Insert bolt, lock-
washer, and washer,
in order shown.
• Tighten with supplied
wrench.
1033443A-/18
Insert plus2 Base Into holdup.
Align
• Insert bolt, and
lock-washer in
order shown.
• Tighten with
adjustable
wrench.
Insert the Plus2 base
into the holdUp tube,
aligning holes.
rotate to uprIght posItIon.
• remove pin and safety clip.
• Lift frame.
• replace pin and safety clip.
LowEr TrAY:
IMPORTANT: Lower tray is
pivot arm
without Yakima logo.
Wheel strap is to your right,
and pivot arm is to your left.
wheel strap