MTD 490-241-0032 Instrucciones De Montaje página 6

15. Take pre-assembled K, L & M clamp assemblies. Mount
assemblies K & L in the determined location on unit. Use
plates M and large bolts N, lock washer T and nuts R to
secure K, L & M assemblies to unit. Now tighten small
bolt P so both clamp assemblies extend equal distance
from frame.
NOTE: Location of lock washer T should be
underneath nut R.
N
M
N
16. Place crossbar (J) against assembly K & L. Center
crossbar (J) against unit. Use two remaining M plates,
large bolts N, lock washer T and nuts R to secure
crossbar.
NOTE: Make sure open end of crossbar is facing up.
Be sure end with tab is facing down.
6
6
T
L
T
R
K
M
L
Upper vertical
handle bars
Lower horizontal
handle bar
J