SSCOR S-SCORT VX2 Manual De Instrucciones De Funcionamiento Y Mantenimiento página 11

Charging/Retention Bracket Mounting Instructions
S-SCORT VX2
The Model 8310 Charging/Retention bracket can be mounted by the base or mounted vertically in order
to hold the S-SCORT VX2 portable suction unit. Mount the unit so the indicator lights on the control
panel are visible to the user. The unit is shipped ready to be mounted vertically, but if that does not fit
your requirements, you can easily modify the unit to mount it by the base.
Note: the mounting bracket will hold the VX-2 in place to a force of ten 'G'. Select and prepare a
mounting surface, and take care in the mounting procedure, so that the bracket and the pump will be
secure at a force equal to, or greater than, 10 G
Vertical Mount
Remove the four 1/4 -20 x 1-1/2 hex head screws from hardware packet. Use the rectangle with the
broken lines on the enclosed Mounting Template to mark the hole placement for a vertical mount. Use
a 5/16"drill. Coat the screws with Loctite (not supplied) before securing the Charging/Retention
Bracket. Put the four 1-1/2" screws through the holes in the charging bracket (Model 8310). Reattach
the washers and nuts to the screws to secure the Charging/Retention bracket in place.
Base Mount (part #8314-7)
Use the rectangle with the solid lines on the enclosed Mounting Template to mark the hole placement
for a base mount. Use a 5/16" drill. Remove the hardware from the hardware packet. Coat the screws
with Loctite (not supplied) and place the screws through the bottom of the Bracket, Retention - Counter
Mount (#8314-7) and through the holes you have drilled. Reattach the washers and nuts to secure the
Bracket, Retention - Counter Mount (#8314-7) in place. Mount the charging bracket (Model 8310) to
the base mount (#8314-7) using the hardware in the hardware packet. Coat the screws with Loctite (not
supplied) before securing the Charging/Retention Bracket to the base mount bracket (#8314-7).
Electrical
Hard wire the DC Charging Cable to the DC Electrical System of the vehicle in front of the master
switch. Plug the cable into the receptacle on the side of the bracket.
The ribbed wire of the charging cable is positive. The inside of the barrel connector to the charging
bracket is positive. The front charging contact, closest to the canister holder, is positive and it matches
the left charging contact on the charging bracket, which is positive.
11