Waters 2695 Guia De Funcionamiento página 104

REPORT: Waters 2695 Separations Module
SERIAL NUMBER:
PRINTED:
USER:
CONFIGURATION: Syringe (250 uL), Loop (100 uL)
SEPARATION METHOD: Default
(1) MOBILE PHASE
Low pressure alarm: Disable
High pressure alarm: Disable
Bubble detect alarm: Alert user
Flow Ramp: 2.00 min (5.0 mL/min/min)
Degasser Mode: On
Degasser fail alarm: Alert user
Pump sealwash period: 1.00
Preferred stroke volume: 130 uL
Gradient:
1. INIT
(2) SAMPLE
Sample temperature:
Sample temp alarm:Log quietly +/- 5C
Syringe draw (rate): Normal (2.50 uL/sec)
(depth): 3 mm from bottom of vial
(3) AUTOSAMPLER
Pre-column volume: 0.0 uL
Post-run delay: 0.00 min
Compression check alarm:
(4) COLUMN
Column temperature: 35C
Column temp alarm:Log quietly +/- 5C
(5) I/O
Chart output:
Table: (min)Event TypeAction
1. 0.00Switch 1On
(6) DETECTORS
2487-1:Enabled
2487-2:Disabled
2410:Enabled
2410 Sensitivity:1
2410 Cell temperature:30.0C
2410 External temp 1: 25.0C
2410 External temp 2: 25.0C
2410 Filter: 3.0 sec
2410 Autozero on inject: Yes
2410 Polarity: [+]
Table:
1. INIT
2. INIT
3. INIT
4. INIT
5. INIT
76 Preparación del Módulo de separaciones 2695
F01SM7885M
05/18/01 02:26:40pm
User
(min) (mL/min) %A
0.000 100.0
4C
Disable
System pressure
Param
(min) Detector Action
2487 (1) Set wavelength
2487 (1) Set filter
486 (1) Set AU full scale
486 (1) Set chart polarity
486 (1) Auto zero
Figura 3-9 Modelo de informe
%B %C %D
0.0 0.0 0.0
Param
254
1.234
[+]
Curve