Attaching/Disconnecting The Battery Pack To/From The Appliance; Operation; Selecting A Tool; Tool-Changing - Parkside PABH 20-LI A1 Traducción Del Manual De Instrucciones Original

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch
middle position (lock). Allow the battery pack
to click into the handle.
Removing the battery pack:
♦ Press the release button
battery pack .

Operation

NOTE
► Push the rotation direction switch
the middle position before carrying out
any work on the power tool (e.g. mainten-
ance, tool-changing, etc.) as well as during
carriage and storage of the power tool.
Unintentional activation of the On/Off
switch can result in injury.

Selecting a tool

■ For hammer drilling, you will need an SDS-plus
drilling tool.
■ For standard drilling in wood, metal, ceramics
and plastic, you can use an appropriate SDS-
plus drilling tool or a tool with a hexagonal
shank.
■ For screwing, use the screwdriver bits
you can attach using the SDS bit adapter

Tool-changing

■ You can use the SDS-plus tool holder
change tools quickly and easily without the
need for any additional tools.
■ The SDS-plus drilling tool moves freely (depend-
ing on the system). This leads to a radial run-out
deviation while idling. This has no effect on the
accuracy of the drill hole as the drill centres
itself during drilling.
PABH 20-Li A1
into the
and remove the
into
that
.
to
■ The SDS-plus bit adapter
ferent types of drills with hexagonal shanks.
■ The dust protection cap
entry of drilling dust into tool holder
operation. Ensure that the dust protection cap
does not get damaged when fitting tools.
NOTE
► A damaged dust protection cap
be replaced immediately. We recommend
having this done by a customer service
workshop.

Fitting an SDS tool

♦ Pull the locking sleeve
the tool in the tool holder
♦ Release the locking sleeve
holder. Check that the tool is properly locked by
pulling it. The system has radial play because of
the design.

Removing an SDS tool

♦ Pull the locking sleeve
move the tool.

Fitting a tool with a hexagonal shank

♦ Pull the locking sleeve
the SDS bit adapter
♦ Release the locking sleeve
holder. Check that the SDS bit adapter
properly locked by pulling it. The SDS bit ad-
apter has radial play because of the design.
♦ Pull the locking sleeve
apter backwards and insert the tool with the
hexagonal shank in the tool holder
can also hold dif-
largely prevents the
during
must
backwards and insert
.
. This locks the
backwards and re-
backwards and insert
in the tool holder .
. This locks the
is
of the SDS bit ad-
.
GB │ MT │
43■