Removing A Tool With A Hexagonal Shank; Operation; Select Operating Mode; Setting The Rotation Direction - Parkside PABH 20-LI A1 Traducción Del Manual De Instrucciones Original

♦ Release the locking sleeve
adapter . This locks the holder. Check that
the tool with the hexagonal shank is properly
locked by pulling it. The tool with the hexagonal
shank has radial play because of the design.
Removing a tool with a hexagonal
shank
♦ Pull the locking sleeve
the tool with the hexagonal shank.

Operation

Select operating mode

■ Use the "Drill/hammer drill" switch
the operating mode of the power tool.
NOTE
► Change the mode only when power tool is
switched off. Otherwise, the tool could be
damaged.
♦ To change the operating mode, turn the "Drill/
hammer drill" switch
Hammer drilling = Hammer ON
Drilling/screwing = Hammer OFF

Setting the rotation direction

NOTE
► Operate the rotation direction switch
when the appliance is at a standstill.
■ You can use the rotation direction switch
change the direction of rotation of the power
tool. This is not possible, however, while the on/
off switch is pressed in.
Clockwise:
♦ For drilling and screwing in screws, turn the
rotation direction switch
as the stop.
│ GB │ MT
■ 44
of the SDS bit
backwards and remove
to select
to the desired position.
only
to
to the left as far
Anti-clockwise:
♦ For undoing and removing screws and nuts, turn
the rotation direction switch
far as the stop.
Switching on/off
Switching on:
♦ To start the power tool, press the on/off switch
and keep it pressed in.
■ The lamp lights up when the on/off switch
is pushed in slightly or fully and illuminates the
working area in low light conditions.
Switching off:
♦ To switch off the power tool, let go of the on/
off switch .
■ At low temperatures, the power tool will only
reach its full hammer performance/strike power
after a certain time.
■ To save energy, do not switch the power tool
on unless you plan to use it.

Set drill/hammer speed

■ You can infinitely adjust the drill/hammer speed
of the switched on power tool, depending on
how far the on/off switch
Pressing the on/off switch
low drill/hammer speed. Increasing pressure
increases the speed.
Run-on brake:
■ When you release the on/off switch
brake stops the chuck and prevents run-on of
the tool.
to the right as
is pressed in.
lightly yields a
, the
PABH 20-Li A1