Test And Install The Door/Window Contact; Overview; Led Indication; Test The Door/Window Contact - Smanos X500 Manual Del Usuario

Test and Install the Door/Window Contact

The contact contains a transmitter and a magnet, which can be mounted on a door,
window, or any object that can be opened or closed. When the transmitter and
magnet are separated, the contact will send a signal to the control panel and the
control panel will trigger an alarm. The tamper switch ensures that sabotage attempts
to disassemble the contact will trigger an alarm.

Overview

LED Indicator
Transmitter
Front side

LED indication

Flash once: Intruder is detected.
Flash once per 3 seconds after triggered:
as possible.
PCB layout
Tamper Switch
Note: When tamper switch is pressed, system will alarm immediately.
41
X500-UM-EN-IT-ES-PT-V1.0.indd 48-49
Tamper Switch
Magnet
Back side
Low battery. Replace the battery as soon
CR2032 Lithium Cell Battery

Test the door/window contact

This is to test whether the contact can work properly.
1. Remove the insulating strip
The contact works immediately.
2. Pay attention to the direction
There are triangle marks on the
side of the transmitter and
magnet. Make sure the triangle
marks is close to each other and
within the range of 1 cm.
3. Test the door/window contact
Press the [Arm ] button. The system switches to the arm state. Separate the
transmitter and magnet with the space more than 2 cm. The red LED on the transmitter
is on. Then, the control panel triggers an alarm. This means the contact works properly.
1
EN
2
＞2cm
42
2016/12/9 9:27:55