Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
The control panel will hoot on-site with indicator flashing, users
will receive an emergency message from App.
Press the
[stay
blinks once, and then press
to mutely arm the system.
Press the
[stay
control blinks once, and then press
3 seconds to mutely disarm the system.
Zone modes
There are three zone modes available for the sensors.
Normal zone:
In arm or home arm state, the detectors set to
normal zone work normally. Once intrusion is detected, the
detectors trigger an alarm.
Home mode zone:
When system is in home arm state, the
detectors set to home mode zone are disarmed. The detectors set
to other zones are armed. That is, partial arm.
24-H zone:
The detector set to 24-H zone trigger an alarm
immediately when detecting intrusion, no matter the system is
armed or disarmed.
Sensors in This Kit
DS2300 Door/Window Contact
Note:
The zone mode of 24-hour zone sensor can not be changed.
07
]
button, the indicator on the remote control
[Arm
]
button within 3 seconds
]
button, the indicator on the remote
[Disarm
]
button within
Zone Mode (Default Setting)
Normal Zone (can be changed through
App)
Door/Window Contact
The contact contains a transmitter and a magnet, which can be
mounted on a door, window or any objects that can be opened
or closed. When the transmitter and magnet are separated over
2 cm, the contact will send a signal to the control panel to trigger
an alarm.
Overview
LED Indicator
Transmitter
Front Side
LED Indication
Blinks once:
Door/window open detected.
Blinks once per 3 seconds after triggered:
notification will be sent to App. Please change battery as soon as
possible.
Note:
When tamper switch is pressed, system will alarm immediately.
Tamper Switch
Magnet
Back Side
Low battery. Push
08
EN
Capítulos
Tabla de contenido
Solución de problemas
